Engine deposits such as gum, varnish and sludge are byproducts of normal operation and motor oils are designed to suspend and remove these deposits. Many vehicles often operate under ‘severe’ conditions, such as ‘stop and go driving’ that can increase these deposits and breakdown the ability of the oil to counteract this situation. In addition, increased under hood temperatures, reduced crankcase capacity, infrequent oil changes will worsen the problem. As these deposit levels build-up in the engine, the result is significantly reduced performance and diminished fuel economy.
BARDAHL Engine Tune-up & Flush is a concentrated blend of solvents, dispersants, detergents and anti-wear additives that will clean and condition the engine, by removing gum and varnish deposits and preventing further deposit formation. Engine Tune-up & Flush will chemically ‘tune-up’ an engine by freeing-up stuck rings, removing deposits from valves, and eliminating sludge from oil gullies and passages, so the engine can operate with greater efficiency.
Pour entire contents into the crankcase. Do not overfill. Run the engine at a fast idle for 20 to 30 minutes, then change the oil and filter. Or just add Engine Tune-Up & Flush to the engine and it will work while driving, with best results normally achieved after 100 to 200 miles. Dispose of any used or unused solution in accordance with the local, state and federal regulations.
P.O. Box 70607 Seattle, Washington 98127
1400 N.W. 52nd Street, Seattle, Washington 98107
Phone: (888) 227-3245
Fax: (206) 784-3219
Customer Service: (888) 227-3245